How to solve the problem of product bursting for mold injection processing manufacturers

Many manufacturers, especially those engaged in Mold injection processing, will find a problem. During the production process, the injection parts will burst due to some processing steps. What is the matter? We can pay attention to several aspects. We can learn more about how the manufacturer handles the problem of product bursting, and interested customers can see it.

How to solve the problem of product bursting for mold injection processing manufacturers

How did this come about? The black production material bursts, and customers generally doubt whether there is too much material added to the nozzle. Because the filler material is one of the causes of bursting.

The other one will burst with a slight press. That position is mainly the bonding line. That is, the Injection Molding parts processing manufacturer did not design the injection point in place when designing the injection point, and made the welding line on the top of the contact hole. It is also a thin position on the outside. Especially in the production of ABS materials, it is easy to break. The experienced design engineer will review the glue feeding point first, and then drive the welding line to the position where no explosion will occur through the glue feeding point.
After the injection molding staff of the injection molding parts processing factory left their posts for more than 20 minutes, they did not shoot off the waste rubber that had been in the gun barrel for too long and had led to the deterioration of the rubber material. Direct production will also lead to burst. In this case, it is difficult to analyze the quality.